Proud Member Of
Pool electrical is life-safety work — not just connecting a pump. Proper bonding, GFCI protection, and code-compliant wiring are required by Florida Building Code and the NEC on every pool installation.
Bonding and grounding are often used interchangeably, but they're different systems that work together. Grounding provides a fault path back to the earth for electrical equipment. Bonding connects all metal components in and around the pool — the water itself, the shell reinforcement, the pump, the ladders, the light housings — to each other, equalizing voltage across all surfaces.
If bonding is missing or done incorrectly, swimmers can experience voltage gradients in the water — a condition that can cause muscle paralysis. This is the reason pool bonding has its own section in the National Electrical Code (NEC Article 680), and it's why we treat pool electrical as life-safety work.
If you're having a pool installed, the electrical planning should happen before excavation begins. The pump and filter equipment location, the pool light conduit path, the sub-panel sizing, and the bonding grid installation all need to be coordinated with the pool contractor and planned before the deck is poured.
Getting the electrical scope established early prevents costly changes after the deck is in. We coordinate with your pool builder on new construction projects — handling the electrical scope while they handle the shell, plumbing, and decking.
Permits are required for pool electrical work in Florida. The permit process includes a final inspection that confirms all bonding, GFCI protection, and equipment wiring is installed correctly. We handle permit coordination as part of every pool electrical job.
Wet-niche pool lights, bonding of the light housing, and proper conduit installation to protect the wiring from deck to water. All pool light circuits are installed to current NEC Article 680 requirements.
Main pump, variable-speed pump, and filtration equipment require dedicated circuits sized for the equipment. We handle sub-panel installation, circuit wiring, and final connection to all equipment.
Spa blowers, heaters, and water feature equipment have their own NEC bonding and circuit protection requirements. We handle both the main pool scope and any spa or water feature circuits included in the project.
Pool bonding connects all conductive components in and around the pool — including the water, reinforcing steel, metal fittings, pump, lights, and ladders — to a common bonding grid. This equalizes voltage across all surfaces so there's no voltage difference that a swimmer could complete. It's required under NEC Article 680 and Florida Building Code on every pool installation.
Yes. Pool electrical is inspected work in Florida — a permit is required for new pool electrical installation and for significant changes to an existing system. We pull the permit and coordinate the final inspection as part of every pool electrical project.
All 125-volt receptacles within 20 feet of the pool edge must be GFCI-protected. Pool pump motors and underwater lighting circuits have specific GFCI or GFPE requirements under NEC Article 680. We ensure all protection is in place and that the installation passes inspection.
Yes. Common issues include tripped GFCI breakers that won't reset (indicating a ground fault in pool equipment), pool lights that stop working, pump motor failures, and bonding system issues. We diagnose and repair existing pool electrical systems as well as handling new installs.
Adding a spa typically requires a dedicated circuit for the spa heater (usually 240V, 50–60A), a circuit for the spa blower, bonding connection of the spa shell and equipment, and GFCI protection. If your existing sub-panel is at capacity, a panel upgrade may also be needed. We'll assess everything during the estimate.